It is more faster and easier to pass the Cisco 200-125 exam by using Certified Cisco CCNA Cisco Certified Network Associate CCNA (v3.0) questuins and answers. Immediate access to the Renew 200-125 Exam and find the same core area 200-125 questions with professionally verified answers, then PASS your exam with a high score now.
Q191. - (Topic 9)
Which two statements about the tunnel mode ipv6ip command are true? (Choose two.)
A. It enables the transmission of IPv6 packets within the configured tunnel.
B. It specifies IPv4 as the encapsulation protocol.
C. It specifies IPv6 as the encapsulation protocol.
D. It specifies IPv6 as the transport protocol.
E. It specifies that the tunnel is a Teredo tunnel.
Q192. - (Topic 4)
Which parameter would you tune to affect the selection of a static route as a backup, when a dynamic protocol is also being used?
A. hop count
B. administrative distance
C. link bandwidth
D. link delay
E. link cost
Q193. - (Topic 5)
Which statement describes the process of dynamically assigning IP addresses by the DHCP server?
A. Addresses are allocated after a negotiation between the server and the host to determine the length of the agreement.
B. Addresses are permanently assigned so that the hosts uses the same address at all times.
C. Addresses are assigned for a fixed period of time, at the end of the period, a new request for an address must be made.
D. Addresses are leased to hosts, which periodically contact the DHCP server to renew the lease.
Topic 6, Network Device Security
234. - (Topic 6)
Refer to exhibit.
A network administrator cannot establish a Telnet session with the indicated router. What is the cause of this failure?
A. A Level 5 password is not set.
B. An ACL is blocking Telnet access.
C. The vty password is missing.
D. The console password is missing.
Q194. - (Topic 3)
Refer to the exhibit.
A new subnet with 60 hosts has been added to the network. Which subnet address should this network use to provide enough usable addresses while wasting the fewest addresses?
Q195. - (Topic 4)
Which command is used to display the collection of OSPF link states?
A. show ip ospf link-state
B. show ip ospf lsa database
C. show ip ospf neighbors
D. show ip ospf database
Q196. - (Topic 3)
Which two are features of IPv6? (Choose two.)
Q197. - (Topic 5)
What levels will be trapped if the administrator executes the command
router(config)# logging trap 4 (Choose four)
Q198. - (Topic 9)
Which type of address is the public IP address of a NAT device?
A. outside global
B. outside local
C. inside global
D. inside local
E. outside public
F. inside public
Q199. - (Topic 7)
Which protocol can cause overload on a CPU of a managed device?
C. IP SLA
Q200. CORRECT TEXT - (Topic 7)
Central Florida Widgets recently installed a new router in their office. Complete the network installation by performing the initial router configurations and configuring R1PV2 routing using the router command line interface (CLI) on the RC.
Configure the router per the following requirements:
Name of the router is R2
Enable. secret password is cisco
The password to access user EXEC mode using the console is cisco2
The password to allow telnet access to the router is cisco3
IPV4 addresses mast be configured as follows:
Ethernet network 184.108.40.206/27 - router has fourth assignable host address in subnet
Serial network is 192.0.2.176/28 - router has last assignable host address in the subnet.
Interfaces should be enabled.
Router protocol is RIPV2
In practical examinations, please note the following, the actual information will prevail.
1. Name or the router is xxx
2. EnablE. secret password is xxx
3. Password In access user EXEC mode using the console is xxx
4. The password to allow telnet access to the router is xxx
5. IP information
R2(config)#enable secret Cisco 1
R2(config)#line console 0
R2(config-line)#password Cisco 2
R2(config)#line vty 0 4
R2(config-line)#password Cisco 3
R2(config-if)#ip address 220.127.116.11 255.255.255.224
R2(config-if)#ip address 192.0.2.190 255.255.255.240
R2#copy run start
To know more about the 200-125, click here.